3. Free the Harness [1].
• 1 Connector [2]
• 1 Wire Saddle [3]
• 1 Screw [4]
4. Remove the Upper Cover Unit [1].
■ Handling after Parts Replacement
1. Execute the tab length adjustment of Z-fold in the following service mode.
on page 79
• Adjustment of the tab length of Z-fold:
SORTER> ADJUST> PF-T-EDG
Removing the Fold-enhancing Unit
■ Preparation
1. Remove this equipment from the host
2. Open the Upper Cover.
3. Remove the Front
Cover."Removing the Front Cover" on page 46
4. Remove the Rear
Cover."Removing the Rear Cover" on page 45
[2]
1x
1x
1x
[4]
machine."Removing the Paper Folding Unit" on page 33
48
4. Parts Replacement and Cleaning
[3]
[1]
[1]
" Adjustment of the Tab Length of Z-fold"