Canon Unit-L1 Service Manual page 58

5. If the distance at the rear side is out of the standard
1. Move the Holder [1] to the rear side.
2. Loosen the 2 screws [1] and insert the Lower Rear Cover Support Plate [2] removed in step 13
Folding Unit" on page
NOTE:
• Place the collar [3] in the notch of the Lower Rear Cover Support Plate.
• Adjust with the Lower Rear Cover Support Plate (height: 6.0 mm).
3. Tighten the 2 screws [2] while pushing the Adjustment Plate [1] upward.
4. Pull out the Lower Rear Cover Support Plate.
[1]
33) as shown in the figure.
2x
2x
[2]
[1]
[2]
[1]
51
4. Parts Replacement and Cleaning
("Removing the Paper
[3]