Removing The Buffer Pass Unit Connecting Plate - Canon Unit-L1 Service Manual

4. Remove the Rear Cover.
■ Procedure
1. Rotate the gear [1] until the position where the screw of the Pushing Plate can be seen, and remove the Pushing
Plate [2].
• 2 Screws [3]
CAUTION:
Do not remove the red screws.

Removing the Buffer Pass Unit Connecting Plate

■ Preparation
1. Remove this equipment from the host
2. Open the Upper Cover.
3. Remove the Front Cover."Removing the Front Cover" on page 46
4. Remove the Rear Cover."Removing the Rear Cover" on page 45
5. Remove the Motor Unit."Removing the Motor Unit" on page 53
"Removing the Rear Cover" on page 45
[3]
2x
[2]
machine."Removing the Paper Folding Unit" on page 33
4. Parts Replacement and Cleaning
73
[3]
[1]