Toro 30609 Operator's Manual page 40

6. Engage the parking brake.
7. Set the throttle to the low I
Performing a Parked Regeneration
Note:
For instructions on unlocking protected menus,
refer to Accessing Protected Menus (page
1. Access the protected menu and unlock the
protected settings submenu
Accessing Protected Menus (page
Figure 38
2. Navigate to the M
button to scroll down to the S
press the right button to select the S
option (Figure 39).
Note:
The InfoCenter should display the PIN
indicator in the upper right corner of the display.
Figure 39
3. In the S M
ERVICE
until the DPF R
EGENERATION
and press the right button to select the DPF
R option
EGENERATION
position.
DLE
20).
(Figure 38); refer to
20).
M , press the center
AIN ENU
M
ERVICE ENU
ERVICE
, press the middle button
ENU
options displays,
(Figure 40).
4. When the "Initiate DPF Regen. Are you sure?"
message displays, press the center button
(Figure
g028523
, and
5. If the coolant temperature is below 60°C (140°F)
the "Insure
message displays.
Observe the temperature in the display, and run
the machine at full throttle until the temperature
reaches 60°C (140°F), then press the center
button.
g212371
Note:
If the coolant temperature is above 60°C
(140°F) this screen is skipped.
40
Figure 40
41).
Figure 41
is running and above 60C/140F"
(Figure 42).
g212138
g212125