Lubrication; Greasing The Bearings And Bushings - Toro 30609 Operator's Manual

Hide thumbs Also See for 30609:
Table of Contents

Advertisement

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease. Also,
lubricate the machine immediately after every
washing.
The grease-fitting locations and quantities are:
Traction Unit
2 brake pedal pivot-shaft bearings
2 front and rear-axle-pivot bushings
2 steering-cylinder-ball joints
2 tie-rod-ball joints
2 king-pin bushings
Note:
Lubricate only the top fitting on the king pin
annually (2 pumps).
Figure 56
Figure 57
(Figure
(Figure
(Figure
58)
(Figure
58)
(Figure
58).
56)
57)
Center Mower Deck
Note:
You may need to raise the deck to expose the
grease fittings for the latch pivot and the lower link.
2 latch pivots
Note:
You may need to manually trip the latches
to gain access to the grease fittings
Use a prybar to close and open the latch.
2 castor-fork-shaft bushings
3 spindle-shaft bearings—located under the pulley
(Figure
2 idler-arm-pivot bushings
g009246
g004687
1. Latch
51
Figure 58
(Figure
60)
(Figure
62)
(Figure
Figure 59
g011499
(Figure
59).
61)
62)
g009440

Advertisement

Table of Contents
loading

This manual is also suitable for:

Groundsmaster 4000

Table of Contents