Locating The Jacking Points; Hauling The Machine; Locating The Tie-Down Points - Toro 30609 Operator's Manual

Figure 52
1. Bypass valve
2. Rotate each valve 3 turns counter-clockwise to
open and allow oil to bypass internally.
Note:
Do not open more than 3 turns. Because
fluid is bypassed, the machine can be slowly
moved without damaging the transmission.
3. Close the bypass valves before starting the
engine.
4. Torque to 70 N∙m (52 ft-lb) to close the valve.
Important:
If you must push or tow the machine
in reverse, bypass the check valve in the 4-wheel
drive manifold. To bypass the check valve,
connect a hose assembly that consists of a hose
(Part No. 95-8843), 2 coupler fittings (Part No.
95-0985), and 2 hydraulic fittings (Part No. 340-77)
to the reverse-traction, pressure-test port, located
on the hydrostat, and to the port located between
ports M8 and P2 on the rear traction manifold,
located behind the front tire.

Locating the Jacking Points

WARNING
Always use jack stands. Do not rely on a jack
or hoist to hold the machine.
Mechanical or hydraulic jacks may fail to
support the machine and cause a serious
injury.
There are jacking points located at the front and rear
of the machine.
•
On the frame at the inside of each front drive tire
•
At the center of the rear axle

Hauling the Machine

•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
Locating the Tie-Down
Points
g020454
There are tie downs located at the front and rear sides
of the machine
Note:
Use properly-rated DOT-approved straps in 4
corners to tie down the machine.
•
2 on the front of the operator's platform
•
Rear bumper
1. Rear tie-down point
46
(Figure 53).
Figure 53
2. Front tie-down points
g033622