Drive System Maintenance; Adjusting The Traction-Pedal Angle; Checking The Planetary-Gear-Drive Oil; Changing The Planetary-Gear-Drive Oil - Toro 30609 Operator's Manual

Drive System
Maintenance
Adjusting the
Traction-Pedal Angle
1. Loosen the 2 nuts and bolts securing the left side
of the traction pedal to the bracket
Figure 80
1. Traction pedal
2. Pivot the pedal to the desired operating angle
and tighten the nuts
Checking the
Planetary-Gear-Drive Oil
Service Interval: Every 400 hours (check if you
notice external leakage).
Every 400 hours
Use high quality SAE 85W-140 gear lube as a
replacement.
1. With machine on level surface, position the
wheel so 1 check plug is at the 12 o'clock
position and the other is at 3 o'clock position
(Figure 81).
(Figure 80).
2. Mounting nuts and bolts
(Figure 80)˙.
1. Check/drain plug (2)
2. Remove the plug at the 3 o'clock position
81).
Note:
The oil level should be at the bottom of
the check-plug hole.
3. If the oil level is low, remove the plug at the 12
o'clock position and add oil until it begins to flow
out of the hole at the 3 o'clock position.
4. Install both plugs.
g009745
Changing the
Planetary-Gear-Drive Oil
Service Interval: After the first 200 hours
Every 800 hours/Yearly (whichever comes first)
1. With the machine on a level surface, position a
wheel so a check plug is at the lowest (6 o'clock)
position (Figure
1. Check/drain plug
2. Place a drain pan under the planetary hub,
remove the plug, and allow the oil to drain.
3. Place a drain pan under the brake housing,
remove the drain plug, and allow the oil to drain
(Figure 83).
60
g019500
Figure 81
82).
Figure 82
g019500
(Figure
g008862