Cleaning And Maintenance - Siemens SIMATIC RTLS Operating Instructions Manual

Battery change
Use approved batteries
Insertion of non-approved or damaged batteries may result in damage to the transponder or
its surroundings. Only use batteries approved by the manufacturer, see section "Technical
specifications (Page 15)". Before inserting a battery, make sure that it is not damaged.
Proceed as follows to replace the battery in the transponder:
1. Open the enclosure at the designated recess on the left-hand side in an upwards direction
using a suitable tool.
2. Remove the battery to be replaced and wait 30 seconds before inserting the new battery
while maintaining the polarity direction.
3. Close the enclosure again until you hear it click into place.
3.2

Cleaning and maintenance

The enclosure may only be opened to change batteries.
The transponder may only be repaired or opened for other types of work by an authorized
maintenance company.
Improper opening or repair of the transponder may result in serious risks for the user.
Opening the transponder without permission renders the warranty of the Siemens AG null
and void.
Do not clean the enclosure with liquids or abrasive, caustic or flammable cleaning products.
SIMATIC RTLS4030T
Operating Instructions, 05/2023, C79000-G8976-C520-08
CAUTION
Installation & Operation
3.2 Cleaning and maintenance
13