Upper Glass Cover; Detaching And Refitting The Rails - Siemens Fornuis HX423 10N Series Instruction Manual

Zone Cleaning agent
Accessories Hot soapy water:
Soak and then clean with a dish cloth or
a brush.
Aluminium baking tray*:
(depending on appliance model)
Dry with a soft cloth.
Do not clean in the dishwasher.
Never use oven cleaner.
To prevent scratches, never touch the
metal surfaces with a knife or a similar
sharp object.
Harsh cleaning products, scratchy
sponges and rough cleaning cloths are
not suitable. Otherwise, you may scratch
the surface.
Rotary spit*
(depending on appliance model)
Hot soapy water:
Clean with a dish cloth or a brush. Do not
clean in the dishwasher.
Meat thermometer*
(depending on appliance model)
Hot soapy water:
Clean with a dish cloth or a brush. Do not
clean in the dishwasher.
Plinth drawer* Hot soapy water:
Clean with a dish cloth.
(depending on
appliance model)
* Optional (available for some appliances, depending on the
appliance model)

Upper glass cover

Before opening the top cover, remove any spills with a cloth.
Use glass cleaner if possible.
For cleaning, remove the top cover. To do this, hold the cover
securely on both sides with both hands and pull it upwards.
If the cover hinges become loose, note the letters marked on
them. The hinge with the letter R must be fitted on the right, and
the hinge with the letter L must be fitted on the left.
After cleaning, re-assemble the top cover following the same
procedure in reverse order.
Only close the top cover once the burners have cooled down.

Detaching and refitting the rails

The rails can be removed for cleaning. The oven must have
cooled down.
Unhooking the rails
Hold the shelf frames from underneath and pull slightly
1.
forward. Pull the extension pins at the bottom of the rails out
of the mounting holes (Fig. A).
Then fold the rails upwards and carefully remove them
2.
(Fig. B).
Clean the rails with washing-up liquid and a sponge. For
stubborn deposits of dirt, use a brush.
Installing the frames
Insert the two hooks carefully into the upper holes. (Figure A-
1.
B)
:
Incorrect assembly!
Never move the frame before the two hooks are fully
anchored in the upper holes. The enamel could be damaged
and may break (figure C).
17