Machining the workpiece
4.10 Editing a program
Setting
Scroll horizontally
Automatic save (only
local and external
drives)
Visible programs
Width of the program
with focus
Cut only after
selecting
Note
All entries that you make here are effective immediately.
Procedure
See also
Replacing program text (Page 115)
122
Meaning
Yes: A horizontal scrollbar is displayed. In this way, you can scroll horizontally
to the end of long lines that would otherwise wrap.
Yes: The changes are saved automatically when you change to another
•
operating area.
No: You are prompted to save when changing to another operating area.
•
Save or reject the changes with the "Yes" and "No" softkeys.
1 - 10
•
Select how many programs can be displayed next to one another in the
editor.
Auto
•
Specifies that the number of programs entered in a job list or up to 10
selected programs will be displayed next to each other.
Here, you enter the width of the program that has the input focus in the editor
as a percentage of the window width.
Yes: The cutting of program sections is possible only when program lines
•
have been selected, i.e. the "Cut" softkey only then is active.
No: The "Cut" softkey is available by default.
•
1.
Select the "Program" operating area.
You have activated the editor.
2.
Press the ">>" and "Settings" softkeys.
The "Settings" window opens.
3.
Make the desired changes here and press the "OK" softkey to confirm
your settings.
Operating Manual, 03/2013, 6FC5398-6AP40-3BA1
Universal