Areas Of Application - Silvercrest SPR 600 A1 Operating Instructions Manual

3) Press the Intensity button
amount of suction force.
CAUTION! There is a risk of bruises, swelling and skin irritation.
Uninterrupted application of the appliance may not last any longer than
5 minutes. The first treatments may not exceed 3 minutes. Do not treat the
same area for too long or with too much force. Do not treat the same area
several times in succession.
Do not use the appliance more often than twice per week.
4) Place the opening of the attachment 9 - q against the skin of your face.
Move the appliance as follows:
Press only hard enough for the attachment 9 - q to make full contact
with the skin so that the appliance cannot draw in outside air. You will feel
a light suction force on the area being treated. Never remain at a fixed
location. Always keep the appliance in motion. Pull the appliance over
each area of skin only a single time!
5) Treat the areas of the face as described in the section Areas of
application.
6) Press the On/Off button
appliance.

Areas of application

Note:
Take care that your skin is firm so that the attachment 9 - q can make a
seal against the skin and not draw in outside air.
If necessary, use one hand to pull the treated area and tighten it while
moving the appliance over the area with your other hand.
│ GB │ IE
■ 16
4 to set the intensity level. This changes the
5 for about 2 seconds to switch off the
SPR 600 A1