Table of Contents
Advertisement
32
MAINTENANCE
MAINTENANCE
Maintaining and Cleaning the
Product
Cleaning the Exterior of the
Product
1
Remove any dust from the air inlet (cover)
using a vacuum cleaner.
Wipe the air outlet and the exterior of the
2
product with a soft cloth.
CAUTION
• Do not clean the product with an alkaline
detergent.
• Do not wipe the product surface using sulfuric
acid, hydrochloric acid, or an organic solvent
(thinner, kerosene, acetone, etc.) or attach
stickers to the product. This may damage the
product surface.
• Be careful not to let water get inside the product.
NOTE
• If dust from the front and rear covers cannot be
removed easily, separate and wash the covers
using water. Then, dry them completely in the
shade.
• If a finger mark or dust on the front and back
covers is difficult to remove, wipe it off with a
microfiber cloth moistened with alcohol.
Cleaning the Dust Sensor
The PM1.0 (super ultra-fine dust) sensor is
the device detecting fine dust and large dust
contamination levels, so it is recommended to clean
the lens periodically, at least once every 2 months.
Based on the front of the product, hold and
1
gently pull both sides of the air inlet (cover) to
separate it.
• The side with the LG logo at the center of
the product is the front of the product.
Status
Display
Air inlet(Cover)
Push the sensor cover up.
2
Put a little water on a cotton swab to wipe the
3
lens, and wipe away any remaining moisture
with a dry cotton swab.
SG
Advertisement
Table of Contents
