efesotomasyon.com -Toshiba inverter,drive,servo,plc
6.18.5 Changing the initial display of the panel
: Initial panel display selection
: Initial remote keypad display selection
• Function
Changing the display format while power is on
When the power is on, the standard monitor mode displays the operation frequency (default setting) in the
format of " " or " ". This format can be changed to any other monitor display format by setting
. This new format, however, will not display an assigned prefix such as or . When ON, the display
of the extension panel is set at .
When On, the main panel and the extension panel can be set to display differently.
■ Parameter setting
6
For details on / = , see the Communications Function Instruction Manual.
6.18.6 Changing display of the status monitor
~ : Status monitor 1 to 6
Change monitor display items in the status monitor mode.
⇒ For details, see chapter 8.
6.18.7 Parameter registration to easy setting mode
~ : Easy setting mode parameter 1 to 24
Up to 24 arbitrary parameters can be registered to easy setting mode.
⇒ See 4.5 for details.
This parameter specifies display format while power is on.
Title
Function
Initial panel display selection
Initial remote keypad display
selection
Adjustment range
0: Operation frequency (Hz/free unit)
1: Frequency command (Hz/free unit)
2: Output current (%/A)
3-17: -
18: Arbitrary display according to
communication
F-62
E6581595
Default setting
0
0