Table of Contents
Advertisement
efesotomasyon.com -Toshiba inverter,drive,servo,plc
List of output terminal function settings
<Explanation of terminology>
Alarm
...... Alarm output when a setting has been exceeded.
Pre-alarm ...... Alarm output when the inverter may cause a trip during continued operation.
List of detection levels for output terminal selection
Parameter programmed
value
Positive
Negative
logic
logic
Note 1) ON with positive logic : Open collector output transistor or relay turned ON.
OFF
ON with negative logic : Open collector output transistor or relay turned OFF.
OFF
☆ For details about the output terminal functions or levels, see 11.7.
Function
Frequency lower limit
Frequency upper limit
Low-speed detection
signal
Output frequency
attainment signal
(acceleration/deceleration
completed)
Set frequency attainment
signal
Fault signal (trip output)
Over-current pre-alarm
Overload pre-alarm
Overheat pre-alarm
Overvoltage pre-alarm
Power circuit
undervoltage detection
: Open collector output transistor or relay turned OFF.
: Open collector output transistor or relay turned ON.
G-9
Parameter
programmed value
Positive
Negative
logic
logic
Small current detection
Over-torque detection
Run/Stop
Cumulative operation time alarm
Forward/reverse run
RS485 communication error
Assigned data output
Parts replacement alarm
Fault signal
(output also at a ready)
Always OFF
Always ON
E6581595
Function
7
Advertisement
Table of Contents
