LG HBP 16H Installation Manual page 18

Module Support BRKT
6.1.2 Contact Information
for use and may pose a danger to people or property. If the battery pack seems to be damaged,
contact LG Electronics regional contact point or your distributor. Use the contacts below
for technical assistance. These phone numbers are available only during business hours on
weekdays.
Europe
Service Address
Telephone
Email
Germany Address
Corporation
Telephone
Email
Benelux Address
Corporation
Telephone
Australia Australia Address
Corporation
Telephone
Email
18
13. Disassemble Module Support BRKTs
with six (6) bolts each.
* Loosen the M6 Flange Bolts (x12)
14. Repack in the box.
LG Electronics ESS | Solar Service
E-Service Haberkorn GmbH Augustenhöhe 7
06493 Harzgerode
(Germany) 0049 (0)39484 / 976 380
(Austria) 0043 (0)720 / 11 66 01
(Switzerland) 0041 (0)44 / 505 11 42
(Benelux) 0031 (0)20 / 225 1660
lge@e-service48.de
LG Electronics Deutschland GmbH
Alfred-Herrhausen-Allee 3-5 65760 Eschborn
0049 (0)18 / 06 807 020
b2b.service@lge.de
LG Electronics Benelux B.V.
Krijgsman 1, 1186 DM, Amstelveen, The
Netherlands
0031 (0)20 456 3100
LG Electronics
2 Wonderland drive, Eastern Creek, NSW 2766,
Australia
0061 1300 152 179
LGEnergyAus@lge.com
7. Appendix
7.1 Connection in BLG RESU16HP parallel battery system
CAUTION
Parallel battery system can only be applied between products of the same energy.
7.1.1 Setting for communication termination resistor (About Section
B)
Section A Section B
When you install the pack as primary, Turn ON the DIP switch for communication termination
resistor.
When you install the pack as secondary, Turn OFF the DIP switch for communication
termination resistor.
(already have)
Inverter
Terminating
resister ON
Primary
Pack
Section C
Section D Section E
1. Case 1 : When installing one battery
pack, Turn ON the DIP switch for
communication termination resistor.
(It is ON when switches are lowered.)