Using The Single-Line Diagram - Hitachi Relion 670 Series Operation Manual

Section 5
Using the HMI
GUID-C98D972D-D1D8-4734-B419-161DBC0DC97B V1 EN-US
Figure 23:
2. Press the wanted function button.
•
•
3.
Press
The panel is also closed after pressing a function button configured for a menu shortcut.
The function buttons are configured with PCM600.
5.1.11

Using the single-line diagram

The single-line diagram is created with PCM600.
1. Select Main menu /Control /Single line diagram .
The single-line diagram view is displayed.
42
Function button panel
Press the wanted function button to jump to a certain menu item.
The menu opens immediately upon pressing the button.
Press the wanted function button for at least 0.5 s to initiate a control signal. The action is
taken once.
To repeat the action, press the button again. If the button is pressed less than 0.5 s, no action
is taken.
to close the function button panel.
© 2017 - 2023 Hitachi Energy. All rights reserved
1MRK500127-UUS Rev. M
IEC13000281-1-en.vsd
GUID-72AC5BD6-D1B5-46D4-83B9-A10870125FCF v7
670 series
Operation manual