Wireless Communication Specifications - Panasonic AccuPulse QP Low Noise Series Operating Instructions Manual

Channel Frequencies:
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
CAUTION:
•
The above wireless device may experience electric wave interference, and thus should not be used
for human safety-related services.

5.2 WIRELESS COMMUNICATION SPECIFICATIONS

[EYFLF1RA, EYFLF1RC, EYFLF1RP, EYFLF2RA, EYFLF2RC, EYFLF2RP]
Antenna
Assembly Qualifier
ø Communication distance between tool and qualifier is horizontally
10 m if there is no barrier in between.
¢ There is a risk of less communication range and/or communication error in conditions
as below.
• Obstacle to disturb radio wave such as metals and/or reinforced concrete between tool and
qualifier.
• Metal cover on qualifier's antenna.
• Operator's body between tool and qualifier.
• Devices creating radio noise such as PC and/or mobile phone near tool and/or qualifier.
¢ Check the conditions below regarding qualifier's location and setting.
• When qualifier is installed or its location is changed, check the signal strength by signal
strength indication lamp.
• If qualifier's reaction speed is significantly slow, change qualifier's location and/or channel
setting.
• If strength of radio signal is weak, change qualifier's location and/or channel setting.
2.410 GHz
2.415 GHz
2.420 GHz
2.425 GHz
2.430 GHz
2.435 GHz
ø about 10 m
‒ 29 ‒
Channel 7 2.440 GHz
Channel 8 2.445 GHz
Channel 9 2.450 GHz
Channel 10 2.455 GHz
Channel 11 2.460 GHz
Channel 12 2.465 GHz
Compatible tool
EN