Panasonic AccuPulse QP Low Noise Series Operating Instructions Manual page 22

[Fig.11]
EN
• The control panel display shows the tool's
mode.
[Fig.25]
Display
- -
CP Operation Disabled Mode
[EYFLF]
Tightening time reminder
The tool is locked when it reaches the set
tightening time, and the main unit stops oper-
ation. This feature is convenient for regular
inspection of the tool performance.
1. Set the tool to setting configuration mode.
(See page 19.)
2. Press the C button twice.
The setting value will be displayed.
3. Press and
change the time.
Operation
4. Press the OK button to accept the new
setting.
NOTE:
• When the remaining time prior to the
tightening time is less than 1 hour, the
display will alternate between the "set
value" and "-1".
If the current tightening time remains
unchanged and the inspection duration
is extended, the new set value must be
greater than the current one.
When it reaches the set time, the display
alternates between the set value and 0.
[EYFLF]
Buzzer setting
You can select from three buzzer modes.
1. Set the tool to setting configuration mode.
(See page 19.)
2. Press the A button twice.
The current setting value will be displayed.
3. Press the
desired value.
Status
Tightening complete
buttons as required to
Display Tightening time
99 99 hours
1 1 hour
0 OFF
and buttons to set the
Display
b0
b1 Buzzer accompanying green indicator
b2 Buzzer accompanying red indicator
4. Press the OK button to accept the new
setting.
NOTE:
The tool ships with the buzzer mode set to
b0 by default.
[EYFLF]
LED light setting
You can select from two LED light modes.
1. Set the tool to setting configuration mode.
(See page 19.)
2. Press the B button once.
The current setting value will be displayed.
3. Press the
desired value.
Display
d1 Linked to LED light button
d2 Linked to trigger switch operation
4. Press the OK button to accept the new
setting.
NOTE:
The tool ships with the LED light mode set
to d1 by default.
[EYFLF]
Speed control function
You can set the speed control (RPM) ON /
OFF and the operation to rotate at low speed
within the set time.
1. Set the tool to setting configuration mode.
(See page 19.)
2. Press the B button three times.
The setting value will be displayed.
3. Press the
desired value.
Operation
P0
P1
4. Press the OK button to accept the new
setting.
‒ 22 ‒
Function
No buzzer
and buttons to set the
Function
and buttons to set the
Function
Speed control ON
Speed control OFF