Htroubleshooting; Introduction; Error Codes - Electrolux SkyLine PremiumS User Manual

Maintenance, inspections, checks and cleaning
Electrical control panel
• check the electrical components installed inside
the electrical control panel. Check the wiring
between the electrical panel and appliance parts
Electrical connection cable
• check the connection cable (replace if
necessary)
General appliance overhaul
• check all components, electrical equipment,
corrosion, pipes...
1. The appliance is designed and built for a duration of about 10 years. After this period of time (from commissioning) the appliance must undergo a general
inspection and overhaul.
H TROUBLESHOOTING
H.1

Introduction

Certain faults may occur during normal use of the appliance. In
some cases, faults can be eliminated easily and quickly by
following the indication below.
The display, if present, always shows a warning message or
alarm describing the occurring fault.
Warnings icon
!
Alarms signalling icon
The alarm icon shows up on the display with a message
indicating the number, the code, the date and issue in progress.
200 - ACUM
17/11/2022 14:22
Communication error with ACU, call
service. For service check J7 or J8 on
UI, X27 on ACU
ID
H.2

Error codes

Check the anomaly indicated by the warning alarm and, if required, contact the Customer Care Service.
Anom- Type of
Description
aly anomaly
ACF Warning Air filter absent
N°323
ACUM Stops oven Main electronic board
not identified
N°200
68
Frequency
• Yearly
• Yearly
1
Every 10 years
For more info about the alarm, touch icon
"Technical Service ID" page or icon
pages.
If the fault persists, contact the Customer Care Service:
1. Disconnect the appliance from the main power supply;
2. Switch off the safety circuit breaker ahead of the appliance;
3. Close the gas and water tap(s), if they are present;
4. Remember to specify:
• the type of fault
• the appliance PNC (product number code)
• the Ser. No. (appliance serial number).
Possible causes
• Filter not detected;
• Possible damage to inter-
nal electric and electronic
components due to air
filter absence.
Communication problem
with the main electronic
board.
Responsability
• Service
• Service
• Service
to open the "Data Monitor"
IMPORTANT
The appliance PNC and serial number are essential
for identifying the type of appliance and date of
manufacture.
Actions
• Refit the filter;
• If the problem persists call Service.
• Switch the oven OFF/ON;
• If the error persists, call Service.
to open the