Install Power Bar Onto Mounting Bars; Check The Evenness; Bring Power Bar Into Position; Attach Power Bar To Mounting Bars - NEC LED-FA025i2-220 User Manual

6.2

Install Power Bar onto Mounting bars

This section is a guide to mounting the Power bar onto the Mounting bars and describes the
following in more detail:
 Prepare the Mounting bars so they are level.
 Position the Power bar on the Mounting bars.
 Then fix the Power bar onto the Mounting bars.

Table 8: Power Bar Installation Requirements

No. of People 2
Prerequisites Mounting bar securely installed
Power bar/LED Wall not connected to mains
Tools Alignment bar
Spirit level
Screwdriver
Equipment Power bar
6.2.1

Check the Evenness

Step 1) Use the Alignment bar and spirit level in combination to check the evenness between
the vertical Mounting bars.
Step 2) If necessary, adjust top and bottom supports accordingly.
6.2.2

Bring Power Bar into Position

Step 3) Bring the Power bar into position to align interface to anchoring point.
Step 4) Align the locating pin of the Power bar to the Mounting bar interface.
Figure 45: Wall Mounting: Attachment of Power Bar (5×5 Frameset)
6.2.3

Attach Power Bar to Mounting bars

Step 5) Use M6×12 Screws (4 per Mounting bar) to attach
Power bar onto the Mounting bars.
Check that the Power bar is level. If necessary, adjust
Step 6)
accordingly.
Step 7) Tighten the screws.

Figure 46: Wall Mounting: Attachment of Power Bar (Detail)

45