Table of Contents
Advertisement
MJ-L7
6.6 DETAILS OF ERROR DISPLAY
Error Display
Details of Error
Measure
Can't REC
e DEFECT occurred 10 times continuously during REC-PLAY.
| e Check if there are scratches, dusts, fingerprints, or
e Recordable cluster became 0 since DEFECT occurred during
black spots on disc. Check if disc fluctuates eccentrically
REC-PLAY.
or moves up and down largely.
Address is unreadable. REC state can not be set for 20
seconds even after try again.
Din UNLOCK
The following occurred for digital signal input from D-IN | e Check if D-IN signal line is normal.
during REC-PAUSE, REC-PLAY, or CD FUNC playback
Digital IN PLL unlocked.
e@ Check if 8.4 MHz clock from MD to CD is normal.
TOC FULL
No area for registering music number and character | e Replace with recording/playback disc with space for
information during REC-PLAY (music name, disc number,
registering UTOC.
etc.)
e Data called MINI of system ID written in ASCII codes in TOC | @ Disc is outside specifications. Replace with different
is incorrect.
disc and check.
e Disc type written in TOC is not pre-mastered MD, recording
MD, or hybrid MD.
Play back MD
Disc only for playback was loaded when attempted to set | e Discis for playback only. Replace with disc for recording.
REC-PAUSE or edit.
PROTECTED
Attempted to record or edit even through REC-proof knob of | e Track attempted to be edited is write-protected. Try
or
disc for recording was in the REC-proof state.
again with different track.
TR PROTECT
Attempted to edit track with write-protect according to | e Restore the REC-proof knob and try again.
information on UTOC.
TEMP OVER
Temperature inside unit (MD unit) was too high due to fault.
| e Check according to TROUBLESHOOTING.
e Is temperature of place where unit is used high?
45
Advertisement
Table of Contents
