Table of Contents
Advertisement
Chapter 1 Installing Windows
N8104-211
N8104-212
N8104-213
N8104-215
N8104-217
N8104-219
3.6.2 Setting up LAN drivers
(1)
Setting link speed
The transfer rate and duplex mode of the network adapter must be the same as those of the switching hub.
Follow the procedure below to specify the transfer rate and duplex mode.
1.
Open the Device Manager.
2.
Expand Network Adapters, and then double-click the name of the network adapter you want to
configure.
The properties of the network adapter will be displayed.
58
Marvell FastLinQ Ethernet 10/25Gb 2-port SFP28 QL41232HLCU Adapter #xx(*1)
Intel(R) Ethernet Network Adapter E810-XXV-2 #xx(*1)
HPE Ethernet 10Gb 2-port 535FLR-T Adapter #xx(*1)
HPE Ethernet 10Gb 2-port 535T Adapter #xx(*1)
Broadcom NetXtreme E-Series Dual-port 10GBASE-T Ethernet OCP 3.0 Adapter #xx(*1)
Broadcom P210tep NetXtreme-E Dual-port 10GBASE-T Ethernet PCIe Adapter #xx(*1)
*1: If there are adapters with the same name, a different identification number will be assigned to xx.
Tips
The ID for N8104-173/177/182/183/185/187/207/210/211 might be a number of
two or more digits. This is due to the LAN driver specifications and not an error.
This number cannot be changed.
Tips
The network adapter name displayed in the device manager may be different from
the one listed above.
In this case, the correct network adapter name can be displayed by following the
procedure below.
1. Start Device Manager.
2. Open Network Adapters, right click on the relevant adapter, and select
Uninstall Device.
3. When Delete the driver software of this device checkbox is displayed,
do not surely put a check.
4. Select Uninstall.
5. Select Scan hardware change from Control.
Important
If you are using a network adapter for N8104-213/215/217/219, changing the
setting is not supported of "Speed & Duplex".
Use int the "Auto Negotiation" of default value.
Tips
If you are using a network adapter for N8104-177/185/187, the network adapter
settings can be set to "10 Gbps Full Duplex" or "25 Gbps Full Duplex", and the
connected switching hub settings can be set to "Auto Negotiation".
Installation Guide (Windows Server 2019)
3. Installing Windows Server 2019
Advertisement
Table of Contents
