Table of Contents
Advertisement
Chapter 3 Appendix
Source
ID
Timing when an event is logged
Windows Server 2019
"System Log"
i40ei65
69
When installing an OS, starting system, or
applying Standard Program Package
i40eb
101
When installing an OS, starting system, or
applying Standard Program Package
icea
101
When installing an OS, starting system, or
applying Standard Program Package
SmartDQa
129
While the system is running
SmartPqi
129
While the system is running
Microsoft-Windows-Time-
Service
134
While the system is running
Disk
157
When creating a RAID
96
Level
Message (Description)
Action
The description for Event ID 69 from source "i40ei65" cannot be
found. Either the component that raises this event is not installed on
Warning
your local computer or the installation is corrupted. You can install or
repair the component on the local computer.
This event does not affect system operation.
HPE Ethernet xGb x-port xxxx Adapter
PROBLEM: Flow Control disabled on this interface. For RDMA
traffic, it is recommended that flow control be enabled end to end on
all network interfaces and switches to avoid performance
Warning
degradation from dropped packets.
ACTION: Enable link level flow control or priority flow control for
network direct port 445 on this interface.
* "x" depends on the system environment.
This event does not affect system operation.
After Standard Program Package is applied, this log will no longer be
registered.
Intel(R) Ethernet Network Adapter E810-XXV-2 xxxxx
PROBLEM: Flow Control disabled on this interface. For RDMA
traffic, it is recommended that flow control be enabled end to end on
all network interfaces and switches to avoid performance
Warning
degradation from dropped packets.
ACTION: Enable link level flow control or priority flow control for
network direct port 445 on this interface.
* "x" depends on the system environment.
This event does not affect system operation.
After Standard Program Package is applied, this log will no longer be
registered.
Reset was issued to the device \Device\RaidPort(x).
Warning
(x is any number)
If this message has been registered as a log during heavy I/O, there
is no problem since the OS has succeeded in retry. Continue using.
Reset was issued to the device \Device\RaidPort(x).
Warning
(x is any number)
Even if the message is registered in the log, there is no problem
because the OS has successfully completed the retry. You don't
need any changes.
NtpClient was unable to set a manual peer to use as a time source
because of DNS resolution error on 'time.windows.com,0x1'.
NtpClient will try again in 15 minutes and double the reattempt
Warning
interval thereafter.
The error was: No such host is known. (0x80072AF9)
This event does not affect system operation if it is not recorded after
connecting to the internet.
Warning
Disk x is suddenly removed.
If you create new RAID on Windows, this event can be registered,
but this does not affect the system operation.
Installation Guide (Windows Server 2019)
1. List of Windows Event Logs
Advertisement
Table of Contents
