Table of Contents
Advertisement
Chapter 1 Installing Windows
3.
On the Advanced tab, set the Speed & Duplex values to the same as those of the switching hub.
4.
Click OK in the Network Adapter Properties dialog box.
5.
Restart the system.
The link speed setting is now complete.
(2)
Configuring Flow Control
Flow Control is a feature to stop transmitting frames temporarily by sending a pause frame to the destination
device when the receive buffer is about to run out. When it receives a pause frame, it regulates the
transmission. Configure the Flow Control following the procedure below
1.
Open the Device Manager.
2.
Expand Network Adapters, and then double-click the name of the network adapter you want to
configure.
The properties of the network adapter will be displayed.
3.
Open Advanced tab, click Flow Control to show Value.
4.
The Value can be changed by the down-arrow button.
5.
Click OK, and then restart the system.
The Flow Control setting is now complete.
(3)
Setting up Wake on LAN
-
When using R120h-1E / R120h-2E / T120h standard network adapters and N8104-172/175/193/194/
195/206/208 with the server, follow the procedure below to set it.
1.
Open the Device Manager.
2.
Expand Network Adapters, and then double-click the name of the network adapter you want to
configure.
The properties of the network adapter will be displayed.
3.
Open Advanced tab, click Enable PME to show Value.
4.
Change the value to Enabled by the down-arrow button.
5.
Click OK, and then restart the system.
Setup is now complete.
Tips
When using the N8104-177/183/187/207/210/211, Link control set to Driver
controlled. *When Link control is Preboot controlled, link speed setting of
BIOS take a priority.
Tips
The settings of Flow Control of the network adapter should match those of the
destination device. For example, if Flow Control in the destination device is set as
Enabled, that in the network adapter should be set as Enabled.
The default value of Flow Control is may become disabled, so if Flow Control in
the destination device is set as Enabled, enable the network adapter.
Tips
For N8104-208/212, it is recommended to set the Receive Buffer value to 4096.
Installation Guide (Windows Server 2019)
3. Installing Windows Server 2019
59
Advertisement
Table of Contents
