Terminals - Mitsubishi Electric 800 Series Instruction Manual

5.2

Terminals

 Option FR-A8AX terminal
Terminal symbol Terminal name
X0 to X15 Digital signal input terminal
Data read timing
DY
input signal terminal
 Inverter terminal
Terminal (signal) Terminal (signal) name
Input X22 Orientation command
ORA Orientation complete
Output
ORM Orientation fault
*1 Refer to the Instruction Manual (Detailed) of the inverter for the details of Pr.178 to Pr.182, Pr.185, or Pr.189 (input terminal function
selection) and Pr.190 to Pr.192, or Pr.195 (output terminal function selection).
52
ORIENTATION CONTROL
Input the digital signal at the relay contact or open collector terminal.
Using Pr.360, speed or position command is selected as the command signal entered.
Use this terminal when a digital signal read timing signal is necessary. Data is read only
during the DY signal is ON.
The X0 to X15 data before the signal is turned OFF is retained by turning OFF the DY
signal.
Used to enter an orientation signal for orientation.
For the X22 signal input, set "22" in any of Pr.178 to Pr.182, Pr.185, or Pr.189 to assign
*1
the function.
Output switches to Low if the orientation has stopped within the orientation complete
width while the start and X22 signals are input.
For the ORA signal output, set "27 (positive logic)" or "127 (negative logic)" in any of
*1
Pr.190 to Pr.192, or Pr.195.
Output switches to Low if the orientation has not stopped within the orientation complete
width while the start and X22 signals are input.
For the ORM signal output, set "28 (positive logic)" or "128 (negative logic)" in any of
*1
Pr.190 to Pr.192, or Pr.195.
Description
Description