Table of Contents
Advertisement
The SETUP Program
9.11 REPLACING A GROUP
The F=pl ace command is used to alter the function or limit specifications for a group in the current
setup.
To use the Fe1 ace command, press [R] from the edit menu:
Add Del
Epl Prt Main
Rl
Feplacse group?
group number ENDLINE
Feplace group athi-HIw
[Y), or NJ
0%
Gropp
on ¥
OF
or
Limit
test
1
OYoMHa?
The edit menu.
Press [R] to select the F=f 1 a2 command.
The program prompts for the group to be replaced.
Enter the group number, and press ENDLINE | .
The program asks if you wish to replace the entire group
specification.
Press
to replace the entire group specification, or
to
replace just the limits.
If the entire group is to be replaced, the program begins to
prompt for the new setup information.
Follow the same
procedure for group entry as described under the Hew
command.
If the entire group is not to be replaced, the program asks
if the limit tests should be replaced.
Press
to replace the limit tests, or
to return to the
edit menu.
The
program
begins
to
prompt
for
the
limit
test
information. Follow the instructions in subsection 9.5,
"Limits."
Advertisement
Table of Contents
