Table of Contents
Advertisement
Strip Chart Program
6.3 CREATING A NEW SETUP
The Me) command is used to create a new list of traces that are to be printed. Each trace requires one or
more of the following specifications:
e The function to be measured (see subsection 6.1, "Measurement Choices").
oe The number of digits of resolution to be used by the HP 3421A.
e The temperature units (C, F, K, or R).
e The conversion subprogram to be called, if needed.
When [inl is selected the program prompts for the number of traces in the new setup. If a setup is
currently defined, the program confirms that you wish to start a new setup.
Let Mew Save Ver
Main?
The file menu.
Press
to select the [eid command.
Destrow setup
OY oH7Y
If a setup exists, the program asks if it may be destroyed.
or
Press
to begin a new setup, or [N] to escape back to the
number of traces ENDLINE
#4
Trace
1
0%
0%
Fe DE
Volts
[V], [A], or [ENDLINE
file menu.
The program prompts for the number of traces to be
printed.
Enter the number of traces, up to 9.
The program displays the number of the trace being
entered.
The function menu.
Press
the
arrow
keysto
choose
the
function
to
be
measured, then press [ ENDLINE ] to select that function.
What you do next depends on the function that you have selected. Refer to the appropriate subsection:
6.3.1, "Signals"; 6. 3.2 "Digital Functions"; or 6.3. 3, "Custom Program." When you have entered all of the
specifications for one trace, you will be prompted to begin entering information for the next trace. When
all traces have been entered, the main menu will reappear.
6-3
Advertisement
Table of Contents
