Table of Contents
Advertisement
The REPORT Program
Mor [N
Channel?
channel number ENDLINE
Feading?
reading number ENDLINE
Soale
max ipan
scale maximum ENDLINE
This option applies if the data file has been generated by
the LIJI5 program and the group contains multiple
readings (several burst measurements, or the group scanned
a series of channels, or a custom program stored multiple
readings). If you select the "Average" option, the readings
in the group are averaged and presented as a single
number. This allows the average of a series of readings to
be plotted against the data from one or more individual
channels.
If there is only one reading per scan, this prompt will not
appear, and the program will skip to the scaling prompts.
Press
to use the average of the group's readings, or
to
use an individual reading for the trace.
If more than one channel has been recorded in a L.[i
group, the program asks for the channel number to use for
the trace.
Enter the number of the HP 3421A channel that was
measured.
If burst readings were stored for a single channel or a
custom program was used, the program asks for the
reading to use.
Enter the number of the reading to use, and press
ENDL INE J .
The program prompts for the scaling values for the strip
chart.
Enter the value which represents the lower bound of the
scale for this trace.
Enter the the value which represents the upper bound of
the scale for this trace.
Repeat the previous steps for each trace in the chart.
11-8
Advertisement
Table of Contents
