Table of Contents
Advertisement
The TRANSFER Program
12.3 STARTING THE TRANSFER PROGRAM
Once the program on the Series 200 computer is ready to receive data from the mailbox, run the transfer
program in the HP-71 Data Acquisition Pac:
FUH TREAMSFER [ENDLINE]
File mame?
file name [ ENDLINE |
Line scanowector Of SH
[or [NJ
Group # CB to end)?
group number ENDLINE
me lect
moans
OYeMT
[Y] or NJ
Start dated
YYCMMSDD
start date ENDLINE
12-4
Run the TEHAMH=ZF EF program.
The program prompts for the name of the data file to be
read.
Enter the name of a LOG, STRIP, or MONITOR data file
and press ENODLINE | .
If the file resides on a mass storage
device,
be
sure
to
include
the
device
specifier, eg:
LOGFILE: HF2 114,
The program displays a status message while the file
header is read.
The program asks if you wish to transfer data in one
scan/vector order.
Press
to transfer data in one reading/vector order, or
to transfer data in one scan/vector order.
If the data file has been created by the L.[I[3 program, the
program prompts for the number of the channel group to
be transferred.
Enter the group number and press ENODLINE | .
The program asks if you wish to transfer only scans taken
in a given time period.
Press
to transfer all scans in the data file for the
specified group, or [Y] to specify a time interval.
If all the scans for the group are to be transferred, skip the
next four steps.
The program asks for the starting date of the time period.
Enter the starting date in 4%T1010} form, and press
ENDL INE J .
Advertisement
Table of Contents
