Hardware Installation Procedures; Installation Of The Inp Pca - HP 30020B Installation And Service Manual

Installation
To set the device number setting on the HP-IB Address Switch, the
following steps should be followed:
1. Identify the number of devices allowed, and the mix
requirements for the GIC (General Interface Channel)
to be used. For configuration details and limit-
ations, refer to the Configuration Guide for your sys-
tem.
2. Identify the number of devices attached to the GIC,
and the highest device number used.
3. Set the INP device number setting on the HP-IB Address
Switch at the next available device number, as long as
this does not exceed number seven.
2-5. HARDWARE INSTALLATION PROCEDURES
2-6. Installation of the INP PCA
Install the INP PCA as follows:
a. Ensure that the HPIB switch is properly configured.
to paragraph 2-4.)
b. Turn off all system power.
I
CAUTION
I
All power must be off when in-
serting or removing any device
or card in the system.
(Refer
c. Open the door of the I/O section card cage on the back of the
HP 3000 HP-IB Version mainframe.
d. Insert the INP PCA board into a vacant card cage slot within
the "device" range (color-coded blue). Any available card
within the specified range can be used, since the device
sequence is determined by the setting of each INP's HP-IB
Address Switch rather than by. the card slot it occupies.
2-4