HP 30020B Installation And Service Manual page 63

Configuring MPE
Prompts 44 through 47 appear only when subtype 0 has been
specified in prompt 13. (DSN/DS, DSN/RJE, and DSN/MRJE)
Step No. Prompt and Response
43
DRIVER NAME? IOINPO
44
PHONELIST?
YES or NO
return
(DSN/DS, DSN/MTS and DSN/RJE)
(DSN/MRJE AND DSN/IMF)
45 PHONE NUMBER? xxx-xxx-xxxx (asked if your response to
44 was yes)
NOTE
European modems and auto call units require a
character to be configured into the phone
number. This delay is achieved by the letter
"D".
The conf igurator file will receive only one
phone number. The phone number is configured
with hyphens--not parenthesis.
The character set needed for the phone number is:
0 through 9
/ (separator used for ACU's that have a second
dial tone detect)
E (end of number)
D (delay of 1 second)
#
(defined by the local telephone system)
*
(defined by the local telephone system)
46 LOCAL ID SEQUENCE? ID sequence or return
(DSN/MRJE ignores your response)
47 REMOTE ID SEQUENCE? ID sequence or return
(DSN/MRJE, DSN/RJE AND DSN/MTS
ignores your response)
A-6