Configuration Overview - HP 30020B Installation And Service Manual

I
CO.NFIGURING MPE
llHH1' H [I
--
~~~~~~~~~.I
A
I
This appendix briefly describes how to configure the MPE
Operating System to include the HP 30020B Intelligent Network
Processor (INP).
CONFIGURATION OVERVIEW
The programs and intrinsics that comprise your data communica-
tions subsystems (such as DSN/DS, DSN/RJE, etc.) are supplied
as part of your MPE Operating System. Only the MPE I/O
configuration needs to be modified to include the Intelligent
Network Processor (INP) and any pseudo devices that may be re-
quired for subsystem operation.
Before configuring MPE, install the INP as described in Section
II, Installation. The ORT number configured on the INP PCA board
(determined from the device number established in step a of para-
graph 2-4, "PCA Jumpers and Switches") should be noted because it
is requested during the configuration dialogue.
If the I/O configuration is compatible, the same INP can be used
for DSN/DS, DSN/RJE, or DSN/MRJE remote activities. Some
information provided in the MPE configuration dialogue may be
relevant only when the INP is used with one particular subsystem.
Any configuration differences or special considerations are noted
in the following dialogue.
Besides configuring the INP and subsystem pseudo devices, you
must, of course, configure any terminals and line printers that
are to be used for the Pass-Through Mode of operation. These are
standard MPE I/O configurations as described in the System
Manager / System Supervisor Reference Manual.
A-1