Two Half Modules In Rack Adapter - HP 211B Operating And Service Manual

Section IT
Paragraphs 2-14 and 2-15
2~2
oO)
ADAPTER
SPACER CLAMP
RETAINING SCREWS
Figure 2-4 Two Half Modules in Rack Adapter
Model 211B
2-14. COMBINING CASE. The combining case is
a full-module unit which accepts varying combina-
tions of submodular units. Being a full-module unit,
it can be bench or rack mounted analogous to any full
module instrument, An illustration of the combining
case is shown in Figure 2-1 . Instructions for in-
stalling the Model 211B in a combining case are given
graphically in Figure 2-2.
2-15, ADAPTER FRAME. The adapter frame isa
rack frame that accepts any combination of sub-mod-
ular units. It can be rack mounted only. An illustration
of the adapter frame is given in Figure 2-3. To as-
semble, refer to Figure 2-4 and proceed as follows
a. Place the adapter frame (1) on edge of bench
as illustrated.
b. Stack the submodular units (2) in the frame.
Place the spacer clamps (3) between instru-
ments. ;
d. Place the spacer clamps (4) on the two end
instruments.
e. Push the combination into the frame.
Insert screws (5) on both sides of frame, and
tighten until submodular instruments are se-
cure in frame.
g. The complete assemble is ready for rack
mounting.