Table of Contents
Advertisement
Figure 14. Chassis installation
After this task is completed
• Reinstall each PSU slot with a PSU or PSU filler (see
Installation of a PSU
• Reinstall the nodes into the chassis.For the procedures of installing a specific node, see the links below:
– SD530 V3:
https://pubs.lenovo.com/sd530-v3/install_a_node_to_chassis
– SD550 V3:
https://pubs.lenovo.com/sd550-v3/install_a_node_to_chassis
• (Optional) If the chassis is to be shipped in the cabinet, follow the steps below to install the shipping
brackets on the rear to secure the chassis to the rack. Otherwise, skip this step.
1.
Align the shipping bracket with the guide holes on the rack and the chassis; then, insert the bracket
push it toward the front to engage the bracket in place.
2.
Tighten the screws to secure the shipping bracket to the chassis and the rack.
3.
Repeat the above steps to install the other rear shipping bracket.
filler).
"Install a hot-swap power supply" on page 29
.
Chapter 4
Hardware replacement procedures
and
23
Advertisement
Table of Contents
