Step 2.
Tighten the thumbscrew located on the top of the chassis.
Figure 25. Installation of the PSU cage
After this task is completed
1. Install the chassis to the rack (see
2. Reinstall the nodes into the chassis.For the procedures of installing a specific node, see the links below:
• SD530 V3:
https://pubs.lenovo.com/sd530-v3/install_a_node_to_chassis
• SD550 V3:
https://pubs.lenovo.com/sd550-v3/install_a_node_to_chassis
3. Reinstall each PSU slot with a PSU or PSU filler (see
Installation of a PSU
"Install the chassis to the rack" on page
filler).
22).
"Install a hot-swap power supply" on page 29
.
Chapter 4
Hardware replacement procedures
and
41