Table of Contents
Advertisement
b.
Remove all the nodes from the chassis.
For the procedures of removing a specific node, see the links below:
• SD530 V3:
• SD550 V3:
c.
Remove all power supply units and PSU fillers from the PSU cage (see
power supply" on page 26
d.
Remove the chassis from the rack (see
lay the chassis on a flat, static-protective surface.
Step 2.
Remove the left and right EIA brackets from the chassis.
a.
Remove the screws that secure the EIA brackets to the chassis.
b.
Remove the EIA brackets from the chassis.
Figure 16. Removal of the EIA brackets
After this task is completed
1. Install a replacement unit (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
https://pubs.lenovo.com/sd530-v3/remove_node_from_chassis
https://pubs.lenovo.com/sd550-v3/remove_node_from_chassis
and
Removal of a PSU
"Install the EIA brackets to the chassis" on page
filler).
"Remove the chassis from the rack" on page
.
Chapter 4
Hardware replacement procedures
"Remove a hot-swap
19); then,
26).
25
Advertisement
Table of Contents
