Appendix A. Hardware Disassembling For Recycle; Disassemble The Chassis For Recycle - Lenovo ThinkSystem D3 User Manual

Appendix A. Hardware disassembling for recycle

Follow instructions in this section to recycle components with compliance with local laws or regulations.

Disassemble the chassis for recycle

Follow instructions in this section to disassemble the ThinkSystem D3 Chassis before recycling the chassis.
About this task
Attention:
• Read "Installation Guidelines" on page 15
you work safely.
Step 1. Power off all the nodes (see
cables from the nodes.
Note: If necessary, press the release clip with a flat-head screwdriver to remove an external
network cable from the rear of a 2U node.
Step 2. Remove all the nodes from the chassis.
For the procedures of removing a specific node, see the links below:
• SD530 V3:
• SD550 V3:
Step 3. Remove all power supply units and PSU fillers from the PSU cage (see
supply" on page 26
Step 4. Remove the chassis from the rack (see
the chassis on a flat, static-protective surface.
Step 5. Remove the PSU cage from the chassis (see
Step 6. Remove the chassis midplane from the PSU cage (see
35).
Step 7. Remove the left and right EIA brackets from the chassis (see
chassis " on page
After disassembling the chassis, recycle the units in compliance with local regulations.
© Copyright Lenovo 2024
and
"Power off the system" on page
https://pubs.lenovo.com/sd530-v3/remove_node_from_chassis
https://pubs.lenovo.com/sd550-v3/remove_node_from_chassis
and Removal of a PSU
24).
"Safety inspection checklist" on page 16
18); then, disconnect all external
filler).
"Remove the chassis from the rack" on page
"Remove the PSU cage" on page
"Remove the chassis midplane" on page
"Remove the EIA brackets from the
to make sure that
"Remove a hot-swap power
19); then, lay
32).
49