Table of Contents
Advertisement
Figure 24. Installation of the chassis midplane
After this task is completed
1. Reinstall the PSU cage to the chassis (see
2. Install the chassis to the rack (see
3. Reinstall the nodes into the chassis.For the procedures of installing a specific node, see the links below:
• SD530 V3:
https://pubs.lenovo.com/sd530-v3/install_a_node_to_chassis
• SD550 V3:
https://pubs.lenovo.com/sd550-v3/install_a_node_to_chassis
4. Reinstall each PSU slot with a PSU or PSU filler (see
Installation of a PSU
Install a PSU cage
Follow instructions in this section to install a PSU cage.
About this task
"Install a PSU cage" on page
"Install the chassis to the rack" on page
filler).
39).
22).
"Install a hot-swap power supply" on page 29
.
Chapter 4
Hardware replacement procedures
and
39
Advertisement
Table of Contents
