Table of Contents
Advertisement
• For PSU slots 2 and 3, the PSU filler must be installed with the latch downward. For PSU slot 1, the
filler must be installed with the latch upward.
Figure 19. Installation of a PSU filler
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a hot-swap power supply
Follow instructions in this section to install a power supply unit (PSU).
About this task
To avoid potential danger, make sure to read and follow the safety information.
S001
DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
• Connect all power cords to a properly wired and grounded electrical outlet/source.
• Connect any equipment that will be attached to this product to properly wired outlets/sources.
• When possible, use one hand only to connect or disconnect signal cables.
• Never turn on any equipment when there is evidence of fire, water, or structural damage.
• The device might have more than one power cord, to remove all electrical current from the
device, ensure that all power cords are disconnected from the power source.
.
Chapter 4
Hardware replacement procedures
29
Advertisement
Table of Contents
