2.2.3
Checking Battery and Connection Status
2.2.3.1
Device in On
Prerequisites: Ensure your WM800 RSM in idle and powered up.
Procedure:
Press the Power Button for less than one second.
Observe the following indications:
Table 9: Bluetooth or Audio LED Indication
Audio/Bluetooth Indicator
Continuous blinking blue
Solid blue
Fast blinking blue twice
(Once)
Result: You hear the following voice prompts or tone:
●
You hear the following voice prompts: "RSM Battery High/Medium/Low" and "Searching for Host/
Connecting/Connected/Reconnecting/Disconnected" (if the WM800 RSM is set to Voice Prompt).
●
"Battery <STATUS> " tone and "Connection Status" tone plays (if the WM800 RSM is set to Tone)
2.2.3.2
Device in Charging State
Prerequisites: Ensure your WM800 RSM in idle state and charging.
Procedure:
Press the Power button for less than one second.
Observe the following indications:
Table 10: Power or Battery LED Indication
Power Indicator
Solid red
Blinking green
Solid green
Chapter 2: WM800 Remote Speaker Microphone
Status
Pairing Mode
●
Connecting
●
Reconnecting
●
Disconnected
Connected
Status
Battery is charged to less than 90% capacity.
Battery is charged to 90% or greater capacity.
Battery is fully charged.
MN010200A01-AC
27