MN010200A01-AC
Chapter 2: WM800 Remote Speaker Microphone
Observe the following in the radio and WM800 for a successful pairing:
●
The WM800 has short beeps until the devices are successfully paired.
●
You hear the "Connected" voice prompt (if Language is selected).
●
The Audio or Bluetooth LED blinks blue after a successful connection.
●
If pairing is unsuccessful, the WM800 returns to pairing mode.
NOTE: The WM800 pairing mode times out in two minutes.
2.3.2.2
Pairing Your WM800 RSM Through Bluetooth
Prerequisites: Ensure that your WM800 RSM is off.
Procedure:
1. Press and hold the Power button until you hear the "Power On" followed by "Searching for Host" voice
prompt and the Audio or Bluetooth LED blinks blue.
2. From the compatible device, enter System Settings, select Bluetooth, select +, and select
WM800_xxxx from the Bluetooth list.
You hear the "Connected" voice prompt and Pairing tone plays when the devices are successfully
paired.
30