Wm800 Rsm Auto Power Off; Subsequent Connection - Motorola WM800 User Manual

3. If the pairing is unsuccessful, the WM800 RSM remains in pairing mode. You can repeat
attempt pairing again.
NOTE: The WM800 RSM will power off automatically after two minutes if not paired. Press
Power button to exit or cancel auto power off.
2.3.3

WM800 RSM Auto Power Off

In pairing mode, WM800 RSM turns off automatically to save battery life.
When WM800 RSM initiates Auto Power Off, observe the following sequence:
● You hear the following voice prompt: "Searching for Host."
● WM800 RSM enters the idle state if there is no button interaction and no device found.
After a certain duration, observe the following sequence:
Table 13: Auto Power off Indicator
Time
At 60 seconds
At 90 seconds
At 110 seconds
● If you press the Power button, you hear the following voice prompts or tone:
○ You hear the following voice prompts: "RSM Battery High/Medium/Low" and "Searching for Host/
Connecting/Connected/Reconnecting/Disconnected" (if the WM800 RSM is set to Voice Prompt).
○ "Battery <STATUS>" tone and "Connection Status" tone play (if the WM800 RSM is set to Tone).
You can cancel Auto Power Off by pressing the Power button when you hear the Voice Prompt: "Auto
Powering Off, press Power button to cancel" or the Tone Prompt: "Auto Power Off Announce Tone".
● If there is no interaction on Power button, WM800 RSM automatically turns off at 120 seconds.
● You can observe the following sequence:
○ Power or Battery LED blinks green twice then stop.
○ You hear the following voice prompt or tone:
■ "Power Off " (if WM800 RSM set to Language).
■ "Power Off" tone plays (if WM800 RSM is set to Tone).
○ WM800 RSM automatically shuts down to save battery life.
2.3.3.1

Subsequent Connection

When Bluetooth link is lost, WM800 RSM and paired host will automatically reestablish the connection when
back in range.
Indication
● Voice Prompt: "Searching for Host" or
● Tone Prompt: "Pairing Tone"
● Voice Prompt: "Searching for Host" or
● Tone Prompt: "Pairing Tone"
● Voice Prompt: "Auto Powering Off, press Power button to cancel" or
● Tone Prompt: "Auto Power Off Announce Tone"
Chapter 2: WM800 Remote Speaker Microphone
MN010200A01-AC
step 2 to
31