Wm800 Rsm General Operations; Powering The Wm800 Rsm On Or Off - Motorola WM800 User Manual

MN010200A01-AC
Chapter 2: WM800 Remote Speaker Microphone
Power Indicator
Blinking Amber
Rapid Blinking Red
Table 11: Bluetooth or Audio LED Indication
Audio/Bluetooth Indicator
Continuous blinking blue
Solid blue
Rapid blinking blue twice
Result: You hear the following voice prompts or tone:
● You hear the following voice prompts: "RSM Battery High/Medium/Low" and "Searching for Host/
Connecting/Connected/Reconnecting/Disconnected" (if the WM800 RSM is set to Voice Prompt).
● "Battery <STATUS>" tone and "Connection Status" tone play (if the WM800 RSM is set to Tone).
2.3

WM800 RSM General Operations

2.3.1

Powering the WM800 RSM On or Off

Procedure:
1. To turn on the WM800 RSM, press and hold the Power button until you hear the "Power On" voice
prompt (if the WM800 RSM is set to Voice Prompt), or the power up tone (if the WM800 RSM is set
to Tone).
2. To turn off the WM800 RSM, press and hold the Power button until you hear the "Power Off" voice
prompt (if the WM800 RSM is set to Voice Prompt), or the radio power down tone (if the WM800
RSM is set to Tone).
3. Observe the following sequence when turning WM800 RSM on or off:
28
Status
Battery is pending charging due to at least one of the
following:
● Battery voltage is too low.
● Battery temperature is too low.
● Battery temperature is too high.
Charging will start automatically when the battery is not
in any of the stated conditions.
Charging Error.
Status
Pairing Mode
● Connecting
● Reconnecting
● Disconnected
Connected