Table of Contents
Advertisement
Electrical connection
Connect the product to a grounded outlet/line
protected by a fuse of suitable capacity as stated
in the "Technical specifications" table. Have the
grounding installation made by a qualified
electrician while using the product with or without
a transformer. Our company shall not be liable for
any damages that will arise due to using the
product without a grounding installation in
accordance with the local regulations.
. DANGER
\ Risk of electric shock, short circuit or
fire by unprofessional installation!
The appliance may be connected to the
mains supply only by an authorized
qualified person and the appliance is only
guaranteed after correct installation.
DANGER
Risk of electric shock, short circuit or
fire by damage of the mains lead!
The mains lead must not be clamped, bent
or trapped or come into contact with hot
parts of the appliance.
If the mains lead is damaged, it must be
replaced by a qualified electrician.
The mains supply data must correspond to the
data specified on the type label of the product. The
rating plate is either seen when the door or the
lower cover is opened or it is located at the rear
wall of the unit depending on the unit type.
Power cable of your product must comply with the
values in "Technical specifications" table.
DANGER
„Risk of electric shock!
'Before starting any work on the electrical
installation, please disconnect the
appliance from the mains supply.
Connecting the power cable
1. Wa power cable is not supplied together
with your product, a power cable thal you
would select from the table in accordance with
ine electrical installation al your home must be
connected to your product by following the
instructions in cable diagram. (Please consider
technical data table, Technical specifications,
page 4
This product must only be installed by a qualfiec
electrician eg local electricity company or NICEIC
registered contractor io a suitable couble-pale
control unit with a minimum contact clearance of
amm in all poles and with a minimum rating
please consider technical data table, Technical
specifications, page dich should be fitted
adiacent to (out not above} Ihe cocker in
accordance with IEE reguiations. Fallure lo observe
this instruction may result in operational problems
and invalidation of the product warranty.
Additional protection by a residual
Icurrent circuit breaker is
Mrecommended.
2. ihe cable must have conductors of sufficiently
high cross sectional area to prevent
overheating and deterioration.
The mains cable must conform lo 856004. This
appliance must be earthed.
The mains cable must pass through the cable
clamp.
The mains cable should be routed away from the
appliance and in particular ventilation siots, the
vent outlet and should not be obstructed when
pushed in to position between the appliance and
the wall and/or cabinets.
3. Open the terminal block cover with a
screwdriver,
4. insert the power cable through the cable
clamp below the terminal and secure it to the
main body with the integrated screw on cable
clamping component,
5. Connect the cables according to the supplied
diagram.
UPPLY CORD
o. After completing the wire connections, o
the terminal Block cover,
Advertisement
Table of Contents
