Honeywell NOTIFIER NFS2-640 Operation Manual page 60

Using the CRT-2 for Read Status
Functions available with the Remote Terminal Mode:
Read Status
Alter Status
Control Functions
C.3 Using the CRT-2 for Read Status
C.3.1 Overview
This section shows how to perform Read Status functions from a CRT-2.
NOTE: See the NFS2-640 Programming Manual for instructions on enabling the CRT port.
For more information see the "Read Status" section of this manual.
Read Point
Alm/Tbl Status
Read All Points
History Step
History All
Alarm History Step
Alarm History All
C.3.2 Accessing Read Status Options
Access the Read Status function from the CRT-2 by following these steps.
1. Turn on the CRT-2, which is connected to the control panel.
2. Press the Read Status function key. The control panel displays the "Read Status" menu
options:
Rd Point=1, Rd Alm/Tbl=2, All Points=3, Hist:Step=4/All=5, Ala-Hist:Step=6/All=7
NFS2-640 Operations P/N 52743:L4 06/10/19
Functions
• Display the status of an individual point (Detector, Module, or Zone).
• Display a list of all the points in Alarm or trouble.
• Display a list of all programmed points in the system.
• Step through the History buffer event by event.
• Display the entire History buffer.
• Step through Alarm History
• Display the entire Alarm History
• N/A
• N/A
Table C.3 Remote Terminal Mode Functions
Function
Read the status of any point in the system (detectors, modules, software
zones, and system parameters).
Display a list of all devices in the system that are in Alarm or trouble.
Display a list of all points programmed in the system. This list will display the
status of all addressable detectors, modules, system parameters and
software zones.
Step through the History buffer one event at a time.
Send the entire History buffer to the CRT, from the most recent event to the
oldest event.
Step through Alarm History one alarm at a time.
Display a history list of all alarms.
Table C.4 Read Status Functions
Remote Terminal Access
Lets you...
Lets you...
69