Table Of Contents - Honeywell NOTIFIER NFS2-640 Operation Manual

Section 3: Operation of the Control Panel
3.1 Overview
This section contains instructions for operating the control panel. Listed below are the topics
detailed in this section:
This manual also contains information on operating the control panel in the appendixes, listed as
follows:
• Appendix A, "Special Zone Operation", on page 56
• Appendix B, "Intelligent Detector Functions", on page 66
• Appendix C, "Remote Terminal Access", on page 67
• Appendix D, "Point and System Troubles Lists", on page 75
WARNING:
!
WHEN USED FOR CO
STATED IN NFPA 12. DO NOT ENTER THE PROTECTED SPACE UNLESS PHYSICAL
LOCKOUT AND OTHER SAFETY PROCEDURES ARE FULLY COMPLETED. DO NOT USE
SOFTWARE DISABLE FUNCTIONS IN THE PANEL AS LOCKOUT.
NFS2-640 Operations P/N 52743:L4 06/10/19
Section
3.2, "Normal Mode of Operation"
3.3, "Fire Alarm Mode of Operation"
3.4, "Mass Notification Mode of Operation"
3.5, "System Trouble Mode of Operation"
3.6, "Security Alarm Mode of Operation"
3.7, "Active Supervisory Signal Mode of Operation"
3.8, "Pre-Alarm Warning Mode of Operation"
3.9, "Disabled Points Mode of Operation"
3.10, "Non-Alarm Mode of Operation"
3.11, "CO Alarm Mode of Operation"
3.12, "Active Trouble Monitor Mode of Operation"
3.12, "Active Trouble Monitor Mode of Operation"
3.13, "Output Circuit Trouble Mode of Operation"
3.14, "Operation of Special System Timers"
3.15, "Waterflow Circuit Operation"
3.16, "Class A and Class X Operation"
RELEASING APPLICATIONS, OBSERVE PROPER PRECAUTIONS AS
2
Refer to Page
page 18
page 18
page 21
page 25
page 27
page 28
page 31
page 32
page 32
page 33
page 35
page 35
page 36
page 38
page 40
page 40
17