Register An Area To Avoid - Panasonic Strada CN-NVD905U Operating Instructions Manual

Register a location (Area to avoid)

Register an Area to avoid

Points and areas to detour around on the route to the
destination can be registered. When an Area to avoid is
registered, route searches will look for routes that avoid
that point or area. (Up to 10 locations)
1 Select [Address Book] from the
Setup menu.
 The Address Book screen is displayed.
2 Select [Register] for "Area to avoid".
3 Search for the center of the Area to
avoid.

Refer to pages 40 – 49 for the search method.
 [Home] is not displayed.
4 Move the cursor to the Area to avoid
and select [Enter].
 Make the setting on a map of 0.5 mile (500 m*)
or more detailed scale.
* This is the scale when "km" is set as the
distance setting
66
66
( page 84).
5 Select or
size of the Area to avoid.
 Select on the bottom line to register the area
centered on the cursor as an Area to avoid.
6 Select [Enter].
 If the destination is set, route searching is
performed.
 The registered Area to avoid is displayed on the
map screen as or
Note:

When [+] or [–] are used to switch the map scale,
the map switches but the size of the square frame
indicating the area does not switch.
 In the following situations, a route search may
produce a route passing through an Area to avoid.
If the vehicle or the destination is inside the Area to

avoid.
When a route that detours around the Area to

avoid cannot be found, such as when there is only
one road between the vehicle position and the
destination.
 Highways, toll roads and ferries within an Area to
avoid are not subject to detour.
To make the highway you want to avoid as a subject
to detour, set the size of the Area to avoid to
set it on the highway.
 When near an Area to avoid, an indirect route may
be produced to avoid any roads entering the Area to
avoid.
(continued)
to change the
(range).
and