Remove the front part of the docking tray. First locate and remove the
4.
rubber pads covering the three screws, then loosen and remove the three
screws. Lift the docking tray up and off the NEC Versa Dock.
Remove the front panel from the NEC Versa Dock by removing the two
5.
screws at the bottom freeing the four tabs from the top of the panel.
A - Front panel tabs (4) B - Front panel screws (2)
6.
Slide the rear part of the docking tray towards the front of the NEC Versa
Dock until it stops.
3-4 Disassembly and Reassembly
Removing the docking tray
Removing the front panel