Power Button - NEC VERSA MINIDOCK 6000 Service Manual

2-8 Setup and Operation
Press the Power button on the front right side of the MiniDock to power
8.
on the NEC Versa. When the Docking Status LED lights a steady green,
the docking process has successfully completed and the NEC Versa is
powered on.
T
If no LEDs are lit, press the main Power switch on the back of the
MiniDock to power on the MiniDock. Next, press the Power button
on the right side of the MiniDock to power on the NEC Versa.
T
If the Docking Status LED blinks green, push a little harder on the
NEC Versa to reseat it for docking. This usually corrects the problem
and the LED will light a steady green.
The LED continues to blink green when something has gone wrong
with the docking sequence due to an error or hardware failure. Pro-
ceed as follows:
Once docked, the NEC Versa is locked onto the MiniDock and cannot be
removed without following the appropriate undocking procedure.
Press the Eject lever to eject the NEC Versa from the MiniDock.
Check that the Docking Status LED is amber.
Starting at step 2 in this procedure, try redocking the system.
Figure 2-10 Power Button