Solving Problems - Epson AP-60 - Projector Sound Solution Installation Manual

Installation guide

Hide thumbs Also See for AP-60 - Projector Sound Solution:

User manual (28 pages)

Manual (5 pages)

Brochure & specs (4 pages)

Table Of Contents

Table of Contents

10 Have an assistant speak normally into the microphone and gradually increase the

control knob on the AP-60 until the notch on the gain control knob is facing straight up.

11 Press the Volume

pressing the button until you hear feedback (howling).

12 Press the Volume

button until the feedback stops, then press the Volume

–

Note

If you hear feedback at low volume levels, remove the audio control panel from the AP-60 (see page 15) and set the

Set the ANTFD switch to the Low or Hi position.

If your room is highly reflective, you may hear a ringing sound when using the AP-60. To reduce the ringing sound,

remove the audio control panel from the AP-60 (see page 15) and set the HF switch to the On position.

13 If you have a second microphone, be sure to set it to Channel 2 and repeat steps 9 and10. When you're

done, the microphones should be the same volume level.

14 Adjust the volume control on the audio device that is connected to Line 1 so that it is 50 to 75 percent of

maximum volume. If your audio device does not have a volume adjustment, continue with step 15.

15 Have an assistant play audio from the device that is connected to Line 1 while speaking into the

microphone.

16 Adjust the

gain control knob on AP-60 until the Line 1 audio is slightly quieter than the

Line 1

microphone audio.

17 Repeat steps 14 to 16 for the audio source connected to Line 2.

18 Have an assistant play audio from the device that is connected to Line 1 or Line 2.

19 Adjust the Balance setting on the AP-60 so that the sound is directed towards the students/audience and

away from where the speaker will be standing.